Light panel glued together, once fully hardened the panel will go back into the 1130

PREPARING ASSEMBLY FOR UPDATED LIGHT SYSTEM

Lucite adhering to nylon honeycomb

Glue bond failed on this side

My clamp to hold PCB behind honeycomb

The Lucite must be glued to the honeycomb and the panel/honeycomb assembly screwed into the pedestal cabinet above the console printer, before the PCB with my lamps can be placed behind and the bulbs inserted into the cells. I had all the bulbs inserted into the PCB ready for the insertion. 

Bulbs inserted into front side of PCB

PARTS ARRIVED TO COMPLETE THE JOB

I had been waiting for a plastic glue, to affix the Lucite to the Nylon honeycomb, plus a rubber lip that would slide of the side of the PCB and fit into the steel U channels fasted to the Lucite blocks. When they finally arrived it was time to do the last bits of assembly. The glue-up was straightforward, held in place by a clamp until it dried. The rubber only needs to be cut to length and slid onto the PCB edge.

Glued but needs 24 hours to reach 80% of final strength