DESIGN OF BULB HOLDER
This holder is designed to take a two position standard (.100" pin distance) header strip in the bottom, with the longer pins sticking up through the holes with a barrier between them. A wire lead incandescent bulb is placed astride the barrier, its wire leads wrapped around the two pins and soldered in place. The side walls keep the bulb protected and aligned. The fillet of the tops of the side walls helps insure that each holder slides into the opening in the 1130 console honeycomb cell.
 |
| View from bottom where header is inserted |
 |
| Drawing views |
 |
| View from above where bulb is placed |
No comments:
Post a Comment