Saturday, November 21, 2026

Built temporary version of Signal Driver board for Virtual 2315 Cartridge Facility for testing

WAITING ON PCBS AND PARTS FOR NEW BOARD

The design for a board that accepts signals generated by the IBM 1130 disk controller logic and redrives them cleanly to the 74LVC244 receiver chips in the Virtual 2315 Cartridge Facility (V2315CF) was completed and is in the fab now being produced. The parts orders were placed for the components as well. 

TEMPORARY VERSION COULD BE BUILT USING SIGNAL CONDITIONER PCB BLANK

Because the circuit is close enough to the Signal Conditioner board that I already built to take signals coming from the V2315CF and condition them just before they enter the 1130 circuits, I realized that I could slightly modify the PCB blank I have for the Signal Conditioner to make the new circuit for testing. 

This would require the removal of the pullup resistor on the output transistor, a change in the values of the two resistors on the operational amplifier, and a change in the reference voltage source. I could use a simple voltage divider, a pair of resistors, to output 1.6V as the reference. 

NOT ENOUGH COMPONENTS IN HOUSE, HAD TO SCROUNGE FOR ALTERNATIVES

I discovered that I did not have enough of the operational amplifier and MOSFET chips on hand to build even a single channel on the temporary board. I had all the rest, but this was a snag that blocked me from early testing.

I hunted through my parts to find a substitute for both. The operational amplifier wasn't that critical, however the challenge was finding one with the same footprint and pin assignment. I didn't have any surface mount N channel MOSFETs, but did have a through hole part.

The op amp I selected, an LM365, has a 8 pin package with different pin arrangements, whereas the original part is a five lead SOT-23 package. This would require fancy wire jumpers and an insecure attachment to the PCB. I clipped the extraneous pins off the new op amp before putting it down on the board, finding two pads that roughly lined up so that there was solder to hold it in place, then added small wire jumpers between the pins and the pads on the PCB. 

The MOSFET I selected, a 2N7000, came in a TO-92 plastic package. I bent the leads and tack soldered them on the board to put in in place of the surface mount original from the design. It is quite insecure but I hope it will hold together long enough to do some testing.

I added a 470 ohm resistor from the output pad on the board where the 2.5V reference voltage source chip originally was installed. This works with the 1K resistor from the 5V regulator to generate roughly 1.6V to the negative input terminals of the op amps, providing the offset needed to cause the Schmitt Trigger levels to be approximately 2.2V going up and 0.55V going down. 

Ugly hack to use substitute parts

ORDERED ADDITIONAL COMPONENTS TO MAKE THE SIGNAL CONDITIONER BOARD

Because I was short on op-amp and MOSFET parts, I wouldn't be able to build the second Signal Conditioner board necessary for the second installation of my V2315CF. I found that the chip I had used, AD8605, was now out of stock and not available until late January. I hunted through substitutes and found that the NCS20166 has the same pin assignments, footprint, and was sufficiently alike that I could use that for the Signal Driver and the second Signal Conditioner boards. 

WORKSHOP UNAFFECTED BY FLOODING, ACCESS RESTORED

The flood waters receded enough to easily reach my workshop and verify that it was untouched by the rising waters. I am back in there working to the extent that my family and other obligations permit.

No comments:

Post a Comment